The T-bar dent puller has multiple replacement heads to repair dents of different shapes. With a simple replacement, you can use heads of different sizes to repair dents of different sizes.
The dent puller kit is suitable for most large dents. The effective effect on the dents of automobiles and other metal surfaces can be widely used on the dents of multiple products.
The T-bar dent puller is made of tempered high-carbon stainless steel and standard stainless steel. Principle of leverage to design the slide hammer dent puller is ergonomic.
Easy to use
(Note: No hot melt glue, hot melt glue gun and glue sticks included)
- Step 1.Clean dent surface.
- Step 2.Put the glue sticks to gun and heat, connect the power source and preheat for 5-10 minutes.S
- tep 3.According to the dent size to choose the Glue Puller Tab, then put the heated glue on puller tab, immediately place puller tab in the center of the dent and hold on until it sticks.
- Step 4.Let the glue cool for about 5-8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter.S
- tep 5.After the glue cooling,use a golden dent lifter or bridge puller to align and press the puller to pull up the dent. Repeat the above steps until the dent disappear.
- Step 6.After finishing the dent,use the alcohol to clean the glue which on the car and the puller tabs.
Note: For detailed operation and more tools, please refer to the instruction manual.
The package includes the following picture：
Reviews
There are no reviews yet.